Access to this file requires a registered account. Log in or use the link below to register an account.
  • Home
  • Electronics
The EV NetMax N8000 is an all-purpose digital audio system controller with outstanding performance features. NetMax is highly flexible due to the modular hardware design, which renders many other applications possible. Four slots with 8- channel audio modules at the rear of the device offer up to 32 local audio channels. Each slot can be equipped either with an audio input module or an audio output module. The modular signal processing in the N8000 is affected on powerful audio signal processors where, depending on the stage of expansion.
Compare Specifications

Knowledgebase

Contact Support

Tel: (866) 782-8346

More Support Resources

AI-1
  • Eight electronically balanced line-level inputs
  • Euroblock connectors
  • 20 KΩ input impedance
  • 117 dB dynamic range for superior sonic quality
  • Automatic configuration
  • IRIS-Net notification of installation and removal
  • On-board DSP (100 MIPS) 
AO-1
  • Eight electronically balanced line-level outputs
  • Euroblock connectors
  • 118 dB dynamic range for superior sonic quality
  • 100 Ω output impedance 
  • Automatic configuration
  • IRIS-Net notification of installation and removal
  • On-board DSP (100 MIPS) 
CM-1
  • Connect NetMax to a CobraNet digital audio network
  • Two 100BASE-TX Ethernet interfaces (IEEE 802.3u compatible) for system redundancy
  • 100 mbps data transmission rate
  • Four serial ports each for input and output for a total of up to 32 ins and 32 outs
  • 48 kHz sample rate and 16-, 20-, or 24-bit word-length
  • Control, monitoring, configuration, and firmware updates via Ethernet 
  • Status LEDs for link, activity, fault, and CobraNet conductor status
DI-1
  • Eight channels of AES/EBU or S/PDIF digital audio
  • Four input connectors, Euroblock or TOSLINK optical
  • Supports sample rates from 32 - 192 kHz
  • Independent sample rate conversion for each input
  • Lock indication LED
  • On-board DSP (100 MIPS) 
DO-1
  • Eight channels of AES/EBU digital audio output
  • Four Euroblock output connectors
  • 48 kHz sample rate
  • +21 dBu maximum output level
  • Automatic configuration via IRIS-Net with installation/removal notification
  • On-board DSP (100 MIPS)
DSP-1
  • Enhanced DSP power for NetMax controllers
  • Adds 300 MIPS computing capacity
  • Easy field installation into chassis card slot
  • 48-bit signal processing
  • Two RAM banks (512k x 24 Bit) for delay lines up to 21.8 seconds 
  • Double-precision DSP algorithms. 
  • Automatic configuration via IRIS-Net with installation/removal notification
MI-1
  • Eight electronically balanced mic/line inputs
  • Euroblock connectors
  • 48 V phantom power
  • Mic/line pad, selectable via IRIS-Net
  • Gain and level adjustable via IRIS-Net
  • Automatic configuration
  • IRIS-Net notification of installation and removal
  • On-board DSP (100 MIPS)
RCM-810
  • Enable powerful control and supervision capabilities
  • Integrate up to 100 devices in each remote control network, 250 with multiple networks
  • Support for 2-, 4-, and 8-channel CPS models
  • Freely programmable control inputs and outputs
  • Load-monitoring for each channel
  • Variable Load Drive for independent channel impedance on 4- and 8-channel amps  (2-10 Ω in 0.1 Ω steps)
UCC1
  • USB-CAN converter for IRIS-Net enabled devices
  • Supports up to 100 CAN devices
  • Parallel CAN connections on RJ-45 Ethercons
  • USB-powered
  • XLR jack for audio bus monitoring
  • 19-inch rackmount panel included
  • Status LED shows CAN activity and device status