RCM-28 OMNEO Network and DSP Module for Tour Grade Amplifiers by Electro-Voice
Access to this file requires a registered account. Log in or use the link below to register an account.


OMNEO Network and DSP Module for Tour Grade Amplifiers

  • RCM-28
The RCM-28 Remote Control Module is a two-channel digital controller module for live sound reinforcement, PA and fixed installation applications. The module can be used in Electro-Voice Tour Grade amplifier models. Installing the RCM-28 turns a conventional amp into a remote amplifier, which, at any time, provides complete overview of the overall system status and control of all system parameters. RCM-28 modules allow the integration of amplifiers into an OMNEO network with up to 100 devices in a single subnet without additional hardware. OMNEO is a media networking architecture for professional applications. Using standard IP Ethernets, media products that integrate OMNEO can be assembled into networks of 2 to 10,000 cooperating devices that exchange studio-quality synchronized multichannel audio and share common control systems. This offers the possibility to control and monitor an entire sound system from one or more PCs using the IRIS-Net - Intelligent Remote & Integrated Supervision - software package. In addition to digital signal processing functions, the RCM-28 also offers a digital audio input (AES/EBU), OMNEO network audio inputs and outputs, and freely programmable control inputs and control outputs.

  • OMNEO Network Interface
  • Extend Tour Grade performance with powerful DSP functionality
  • Advanced FIR-Drive loudspeaker optimization
  • High precision load impedance supervision
  • Two GPI and two GPO ports
  • One-button system test for fast, complete check of connected cables and components
  • Pilot tone detection for cable supervision
  • Six recallable DSP/configuration presets
  • Compatibility with any Dante network
A/D Conversion 24 Bit linear, sigma-delta, 128x oversampling
Analog Inputs 2 audio inputs on internal slot connector, pre-/post fader selectable
CAN Bus Interface None
Control Protocol OMNEO
D/A Conversion 24 Bit linear, sigma-delta, 128x oversampling
Data Format 24 Bit linear A/D and D/A conversion, 48 Bit processing
Digital Inputs Omneo Network and AES3 (AES/EBU) format, XLR in/ thru connectors
FIR-Drive Yes
GPIO Control Ports 1 x 6-pole Euro block 2 control inputs (Uin max. 5 V) 2 control outputs (2x 100 mA) 2 reference outputs (+5 V, 200 mA; GND)
Internal Processing Dual core DSP, 500 MIPS
Network Control (IRIS-Net) Yes
Sample Rate 48 kHz
Sample Rate Conversion (SRC) 32–192 kHz, internal sample rate- converter
Signal-to-Noise Ratio (A-weighted) weighted) ADC: 120 dB typical DAC: 120 dB typical AES3: 128 dB typical Analog In to Analog Out: 116 dB typical dB
THD+N < 0.002 %
Height 2RU 3.17" (80.4 mm)
Width 3.33" (84.7 mm)
Depth 9.09" (230.8 mm)
Weight Net 14.11 oz (400 g)
Optional accessories
may be shown
Hover over image to zoom
Click image for full size