P3000RL
1800 W per channel remote control amplifier
- High-power performance and control, installed or on tour
- 1800 W per channel (2 Ω)
- Class-AB design
- IRIS-Net enabled for remote control, monitoring, and DSP processing via included RCM-24 module
- Eight recallable DSP/configuration presets
- System check button for fast, complete test of all connected cables and loudspeaker components
- Two GPI and two GPO ports
- Parallel RJ-45 CAN bus connectors
- Pilot tone detection for cable supervision
| Amplifier Gain | 34 dB |
| Connector Type | Speakon NL4 |
| Continuous Rated Power (1 kHz, THD 1%) 2Ω | 1800 Watts |
| Continuous Rated Power (1 kHz, THD 1%) 4Ω | 1300 Watts |
| Continuous Rated Power (1 kHz, THD 1%) 8Ω | 850 Watts |
| Continuous Rated Power (20-20 kHz, THD<0,2%) 4Ω | 1200 Watts |
| Continuous Rated Power (20-20 kHz, THD<0,2%) 8Ω | 750 Watts |
| Control Protocol | CAN-Bus |
| Controls | 2 x 0 V, 5V free configurable, Easy-Remote |
| Cooling | Front-to-rear, three 4-stage fans |
| DIM 30 | < 0.01 % |
| Electronics Type | Amplifier |
| FIR-Drive | No |
| Frequency Response | 20 - 20,000 Hz -1 dB |
| Impedance | 2/4/8 Ω |
| Input Impedance (Balanced) | 20 kΩ XLR Input |
| Input Sensitivity | 1.55 V +6dBu |
| Intermodulation Distortion (SMPTE) | < 0.001 % |
| Maximum Bridged Output 4Ω | 3600 Watts |
| Maximum Bridged Output 8Ω | 2600 Watts |
| Maximum Input Voltage | 8.7V +21 dBu |
| Network Control (IRIS-Net) | Yes |
| Serial Interface | Network: CAN, 2 RJ45 (CAT-5 Cabling), RS-232 for media control systems |
| Signal-to-Noise Ratio (A-weighted) | 109 dB |
| Topology | Class-AB |
| Total Harmonic Distortion | < 0.05 % |
| Height | 3RU 132.5 mm (5.22") |
| Width | 483 mm (19.02") |
| Depth | 390 mm (15.35") |
| Weight Net | 30 kg (66.14 lbs) |
Brochures 
UCC1
Remote control interface for IRIS-NetOptional accessories
may be shown
may be shown
Hover over image to zoom
Click image for fullsize
.JPG?width=50&height=50&cropratio=1:1&image=/sitefiles/pr_images/CCMA 2010(19).JPG)
Warranty Document